Page 1 of 1

OSW Direct Drive and other bits

Posted: Tue Nov 10, 2020 11:54 pm
by Jetboy
Posted up on SCU as well

Bought most of this stuff a few years back, had it up and running a few times and then life did a bit of a flip on me and hasn't been fired back up in about 3-4 years :( so might as well be giving someone else enjoyment

OSW Direct Drive Wheel
I should say this is not a plug and play wheel, took me a bit of time reading the iRacing forums and poking around to get it working (luckily there are a bunch of people on there with them and they are MORE than helpful to get you up and running)

Discovery Shield
PSP-600-48 (fan-cooled 600W)
Mean Well RS-25-24
10 Ohm 100W Braking Resistor
130ST-M10010 (small mige) upgraded to 5000ppr encoder
Servo Mount
24v to 12v adapter for large case fan to work
HRS hub
QR1 base side QR
P290 Sparco 50mm QR1 wheel side

Looking for $1k for that setup

Also have a Fanatec Clubsport M3 Rim that I was adapting to go on the wheel with a Leo Bodnar USB adapter

Fanatec Clubsport Shifter V1, needs a USB adapter to work (initially had it running through a clubsport base but that died and couldn't figure out the fix, even with another dead base to salvage parts from)

Slightly dicey bit of kit as well,
DSD Pedals They are first rev pedals (images at the bottom of the page) and pretty sure one of the pots needs replacing as always had issues getting them to calibrate properly, when they did they were awesome but obviously they need some love

Re: OSW Direct Drive and other bits

Posted: Tue Dec 08, 2020 6:00 pm
by Kiwi
Generally interested , you have a pm.

Re: OSW Direct Drive and other bits

Posted: Thu Dec 10, 2020 8:52 pm
by Jetboy
Really must get the bench tidied up, have all the shifter etc for the BMW wheel, had removed it to look at getting an adapter machined up as the hole patterns don't line up from the Fanatec hub to the Q1R

Re: OSW Direct Drive and other bits

Posted: Sat Aug 21, 2021 4:35 pm
by BigMassiveHug
do you still have the quick release for the fanatec rim? I have the csw and am looking at upgrading to an osw eventually so would be keen on the adapter too. Plus im keen on the shifter as well.